These flanges are used for securing which are normally made from a flat profile with a series of evenly distbeaduted drilled holes within the same basic diameter.
Flanges are connected to the ends of any tube or accessory and in the case of "MULTIFORM" system parts, they are normally attached between a bead which acts as a reinforcement and a lower limit and a flange of 10 mm, which is made at the end of the part and which acts as an upper limit. This guarantees perfect positioning while allowing the flange to turn on its axis in order to match the opposite plate.
KMH system sections are usually delivered with this part welded directly to the tube.
The assembly of tubes using bolted flanges facilitates operations at higher pressures when compared with other connection systems, providing maximum rigidity to the installation while offering an acceptable level of sealing, which can even be improved further with the fitting of a EPDM, silicone, FPM, NBR, cardboard or Klingerit seal between one flange and another.
These flanges are suitable for application in determined points of ventilation, air-conditioning and air expulsion networks, in powder collection networks and in the pneumatic transport of materials and particles.